La Crosse Technology CA84688 Manuel D'instructions page 14

Mount TX141Wv2 Sensor
• For the most accurate wind speed readings, mount the
TX141Wv2 sensor as the highest object for 50 feet in all
directions.
• Mount sensor vertically with the wind cups on top.
• The maximum wireless transmission range to the wind
station is over 330 feet (100 meters) in open air, not
including walls or trees.
1. Insert mounting pole into sensor.
2. Tighten screws
3. Insert bottom of pole into mounting bracket
4. Tighten knob to secure
5. Use screws through the bottom of the mounting bracket
to attach.
6. The sensor can be mounted from the bottom or side.
Alternatively:
1. Insert your own mounting pole into the sensor.
2. Tighten screws
3. Mounting bracket would not be used.
Mount Add-on TX141TH-BCH Sensor
Mounting Hole
CA84688
• To mount the sensor, use the hole at the top to either
hang it from the back using a nail, or inserts one mounting
screw through the front
• Mount the TX141TH-BCH sensor on a north-facing wall or
in any shaded area. Under an eave or deck rail is
preferred.
• The maximum wireless transmission range to the weather
station is over 330 feet (100 meters) in open air, not
including walls or floors.
• Be sure the sensor is mounted vertically, to allow
moisture to drain out properly.
• http://bit.ly/TH_SensorMounting
Wind Speed Weather Station
Wind cups
Battery cover
Mounting pole
Side Mount
Option
Red LED
Flashes during
transmission
Mounting
Bracket
Page | 14