Télécharger Imprimer la page

La Crosse Technology CA84688 Manuel D'instructions page 13

Publicité

Les langues disponibles

Les langues disponibles

Connect Add-on Sensors to Station
• The wind station will accommodate up to two additional (TX141TH-BCH)* Thermo-Hygro sensors on
channels 2 & 3.
*Additional sensors sold separately & can be purchased here:
www.lacrossetechnology.com/tx141th-bch-temperature-humidity-sensor
Note: No additional TX141Wv2 wind speed sensors may be added.
Connect add-on sensor(s) to the wind station:
1. Remove the battery cover from all add-on sensors (leave off ).
2. Set the first additional sensor to Channel 2 and insert 2 "AA" batteries.
3. Set the second additional sensor to Channel 3 and insert 2 ""AA"" batteries.
4. Hold the TEMP button on the station for 3 seconds to search for sensors.
5. Press the TX button on each sensor.
6. When connection is established, the temperature and humidity for each of the selected channels will
appear.
7. Install the battery covers on each sensor.
8. Keep sensors and the wind station 5-10 feet apart for 15 minutes for a solid connection.
9. After 15 minutes, place the remote sensors in appropriate shaded locations.
10. Press and release the -/CH button to view channels 1,2 or 3 on the wind station.
Note: CH 1 will show consistently. CH 2 and CH 3 will only show if sensors are connected to the station
on those channels.
View Channels (when add-on sensors in use)
• Press the -/CH button to toggle between remote
sensor channels when multiple sensors are used.
• Channels are indicated with CH 1, CH 2 or CH 3,
in the outdoor temperature area.
Note: When using multiple TH sensors, select the
channel by pressing the -/CH button prior to view-
ing HI | LO readings or setting temperature/humidity
Alerts
CA84688
Wind Speed Weather Station
CH 2
Page | 13

Publicité

loading