Braun 9 Serie Mode D'emploi page 10

Trouble-Shooting
Problem: Possible reason:
SHAVER
Shaver does not start 1. Travel lock is activated.
when pressing the 2. This appliance can only be
start button.
Shaver does not Ambient temperature is out of
charge completely valid range.
and keeps blinking.
Charging does not 1. Shaver is not placed properly
start when connected
to power socket or 2. Sometimes charging could
put in Clean&Charge
Station.
3. Ambient temperature is out
4. Special cord set is not
Unpleasant smell 1. Shaver head is cleaned with
from the shaver head.
2. Cleaning cartridge is in use
Battery performance 1. Shaver head is regularly
dropped significantly.
2. Foil and cutter are worn
Shaving performance 1. Shaving system is clogged.
dropped significantly. 2. Foil and cutter are worn.
Shaver turns off with Foil and cutter are worn which
fully charged battery. requires more power than
the motor can deliver. The
appliance turns off.
Shaver head is 1. Drain of the Clean&Charge
damp.
2. Cleaning cartridge has been
CLEAN&CHARGE STATION
Cleaning does not 1. Shaver is not placed properly
start when pressing
the start button. 2. Cleaning cartridge does not
3. Appliance is in stand-by
Increased Drain of the Clean&Charge
consumption of Station is clogged.
cleaning fluid.
10
All manuals and user guides at all-guides.com
operated cordless.
in the Clean&Charge Station.
start delayed (e.g. after long
storage).
of valid range.
plugged in properly.
water.
for more than 8 weeks.
cleaned with water but not
lubricated.
which requires more power
for each shave.
Station is clogged.
used for quite a while.
in the Clean&Charge Station.
contain enough cleaning fluid
(level indicator blinks red).
mode.
Remedy:
1. Press the on/off switch for 3 seconds to unlock
the shaver.
2. Unplug the shaver.
Recommended ambient temperature for charging is
5 °C to 35 °C.
1. Contacts of shaver need to align with contacts in
the Clean&Charge Station.
2. Wait a few minutes, if charging will start auto-
matically.
3. Recommended ambient temperature for charging
is 5 °C to 35 °C.
4. Special cord set needs to snap into place.
1. When cleaning the shaver head with water only
use hot water and from time to time some liquid
soap (without abrasive substances). Remove Foil
& Cutter cassette to let it dry.
2. Change cleaning cartridge at least every 8 weeks.
1. If the shaver is regularly cleaned with water, apply
a drop of light machine oil on top of the foil once
a week for lubrication.
2. Replace Foil & Cutter cassette.
1. Soak the Foil & Cutter cassette in hot water with
a drop of dish liquid. Afterwards rinse it properly
and tap it out. Once dry apply a drop of light
machine oil on the foil.
2. Replace Foil & Cutter cassette.
– Replace Foil & Cutter cassette.
– Regularly oil the shaving system, especially when
cleaning with water only.
1. Clean the drain with a wooden toothpick.
2. The ethanol/isopropanol proportion has
decreased while the oil proportion has increased.
Remove residue with a cloth.
1. Insert shaver into the Clean&Charge Station
(contacts of the shaver need to align with
contacts in the station).
2. Insert new cleaning cartridge.
3. Press start button again.
– Clean the drain with a wooden toothpick.
– Regularly wipe the tub clean.