CASUALPLAY Baby 0+ SAFE TECH Mode D'emploi page 22

Fitting the foot cover
• Place the foot cover on the
elastic band on the feet (fig.2).
Adjusting the hood
• The hood has several positions.
• To unfold it, pull the hood upwards (fig.3). Do the opposite to fold it.
Adjusting the carrying handle
• Make sure you change the handle position correctly (fig.4-5).
A. Stability.
B. Installing on a pushchair.
C. Carrying, rocking, installing in the car using the Base fix Baby 0
separately).
D. Installing in the car.
• Press the two buttons on both sides of the handle to change its position.
• Move the handle to the required position until it clicks into place.
Headrest adaptor
• The headrest adaptor is designed to provide side support for the baby's head and can
be adjusted as the baby grows.
• It is advisable to use the headrest adaptor while it is suitable for the baby.
• When you need to remove the headrest adaptor, simply unfasten the harness buckle,
remove the chest protector pads and pass the harness straps through the openings in
the headrest adaptor.
• Fit the chest protector pads again.
• To fit the headrest adaptor, follow the same steps in reverse order.
Adjusting the height of the harness
• Find the distribution plate found on the back of the
release the two shoulder straps of the harness (fig.6). Pass the shoulder straps out
through the slots in the backrest and in the upholstery.
20
All manuals and user guides at all-guides.com
Baby 0
+
, fasten the Velcro on the sides and the
SAFE TECH
Baby 0
SAFE TECH
+
backrest and
SAFE TECH
+
(sold