Initialisation Of The Cg-1; Setting The Gyro Sensitivity "Gain" (Dual Mode) - Carson Gyro CG-1 Mode D'emploi

10. Initialisation of the CG-1

GB
The gyro must be initialised for a correct function. This internal
coordination is carried out automatically after switching on the
receiving system and lasts approx. 2-3 seconds. During this
time the model and the gyro must not be moved or turned. After
successful completion of the initialisation, the LED display (4)
lights up.
If, for instance, the controll signal from
the receiver is missing, the LED display
lights up after initialisation. In this case the
receiving system must be switched off, the
cause of the error removed and the gyro
restarted.
4
11. Setting the gyro sensitivity "GAIN"
(dual mode)
The sensitivity of the gyro CG-1 system is 0 - 100% and can be
set best with a roll bar (dispenser). For the sensitivity settings of
0%, the stabilising effect of the gyro is deactivated and at 100%
the highest gyro sensitivity achieved.
With the help of the sliding controller (sensor) on the sender, not
only the gyro CG-1 sensitivity is set, but at the same time the
operation mode switched. For this reason, the central position of
the sliding controller (50% sensor route) corresponds to a gyro
sensitivity of 0%.
15
CARSON Gyro 507027