Setting The Electronic Speed Controller By Means Of The Setup Card - Carson Dragster Sport SL Mode D'emploi

6. Setting the electronic speed controller by
means of the setup card
1. Connect the ESC to a suitable charged battery pack. Make sure the
polarity is correct.
2. Connect the receiver cable to the program card, making sure of the
correct polarity.
3. Select the desired function for your speed controller and insert the
jumper (connector) in the appropriate places.
4. Turn on the ESC and wait a few seconds. The red LED on the program
card will flash, then becomes solid to indicate settings are saved.
5. Turn off the ESC and unplug the program before use again.
Trouble-shooting
If the red LED on the program card does not light up, make sure the recei-
ver cable is connected with the correct polarity and make sure the battery
pack is fully charged.
RX (receiver)
connection
The following values
can be set using the card:
1 Motor Timing
2 Acceleration
3 Setting the braking power
4 Choice dragbrake
5 Choice of rotation
6 Choice of battery type
CARSON DRAGSTER Brushless Controller
LED
GB
Jumper
31