Table Des Matières; Safety - Baumer CombiLyz AFI4 Notice D'utilisation

Table of contents
1. Safety .......................................................... 3
2. Construction and function ........................... 4
3. Symbols in warning signs ............................ 4
4. Transport and storage ................................. 5
5. Mounting ..................................................... 5
6. Electrical connection ................................... 8
7. Configuration ............................................. 10
1.

Safety

Intended use
The sensor must be used solely for conductivity
measurements of liquids.
The sensor must only be used for media against
which the housing material and sensor tip are
resistant.
Staff qualification
Only employ staff who are trained for the activities
described. This applies in particular to assembly,
installation, configuration and troubleshooting.
Make sure that the staff have read and understood
these instructions.
Electrical connection and EMC
All electrical wirings must comply with local
standards and connections must be made
according to the connection diagrams.
www.baumer.com
Conductivity measurement
CombiLyz AFI4/AFI5
Inductive conductivity transmitter
8. Operation ...................................................12
9. Troubleshooting ..........................................13
10. Cleaning, maintenance and repair..............13
11. Disposal .....................................................13
12. Accessories ................................................13
13. Technical data ............................................14
14. Configuration overview ...............................15
Technical condition
Only use the sensor in perfect technical condition.
Only use Baumer accessories.
Baumer will accept no liability for other
manufacturers' accessories.
Only the DFON display may be replaced and only
Baumer may perform repairs on the device.
Operation
The power supply and environmental conditions
must comply with the specifications of the
device. The device is not approved for electrical
installations in explosion hazard areas.
Before switching the device on and off, possible
effects on other equipment and the processing
system must be checked.
Risk of burns from hot media
During operation the sensor housing may warm
up to over 50 ºC. When working with hot media
provide protection against burns.
Operating Instructions 3 / 52