Braun Wet & Dry 7 Serie Mode D'emploi page 7

All manuals and user guides at all-guides.com
Before shaving
Prior to fi rst use you must connect the shaver to
an electrical outlet using the special cord set
or alternatively proceed as below.
Installing the Clean&Renew station
• Using the special cord set
station power socket
2
• Press the lift button
• Hold the cleaning cartridge
stable surface (e.g. table).
• Carefully remove the lid from the cartridge.
• Slide the cartridge into the base of the station
as far as it will go.
• Slowly close the housing by pushing it down
until it locks.
The cleaning fl uid display
fl uid is in the cartridge:
up to 30 cleaning cycles available
up to 7 cleaning cycles remaining
new cartridge required
Charging and cleaning the shaver
Insert the shaver head down into the cleaning
u
station. The contacts
shaver will align with the contacts
cleaning station. Important: The shaver needs
to be dry and free from any foam or soap
residue!
If required, the Clean&Renew station will auto-
matically charge the shaver. The hygiene status
of the shaver will also be analyzed and one of
the following cleaning program indicators
light up:
shaver is clean
short economical cleaning required
normal level of cleaning required
high intensive cleaning required
If the station selects one of the required cleaning
programs, it will not start unless you press the
4
start button . For best shaving results, we
recommend cleaning after each shave.
p
p
, connect the
6
to an electrical outlet.
to open the housing.
7
down on a fl at,
1
will show how much
on the back of the
3
in the
5
will
1
2
7