Publicité
Les langues disponibles
Les langues disponibles
Problem
The drive of the blades do not engage.
The transaxle leaks oil.
The cutting result is unsatisfactory.
Transportation
•
Do not tow the product.
•
The product is heavy and can cause crush
injuries. Be careful when you load it onto or off
a vehicle or trailer.
•
Load the product in reverse on approved ramps
of a maximum operation angle of 10°. Do not lift
the product.
•
Use an approved trailer for transportation of the
product.
•
Make sure that you have knowledge of local
road traffic regulations before transportation of
the product in a trailer or on roads.
•
Lock the product with approved devices, such
as straps. Use tie-down points on the product
or applicable areas of the frame. The parking
brake is not sufficient to lock the product during
transportation.
Storage
Prepare the product for storage at the end of the
season, and before more than 30 days of storage. If
you keep fuel in the fuel tank for 30 days or more,
tacky particles can cause blockage in the carburetor.
This has a negative effect on the engine function.
24
Cause
The drive belt on the mower deck is loose.
The electromagnetic coupling contact is loose.
The drive of the blade is damaged or loose from the cable con-
nectors.
A fuse is blown.
The seals, housing or gaskets are damaged.
There is air in the hydraulic system.
The tire pressure is different on the right and left sides. Refer to
Tire pressure on page 19 .
The blades are damaged.
The suspension of the cutting deck is not level.
The blades are blunt. Refer to
20 .
The product is operated at too high forward or rearward speed.
Refer to
The grass is long. Refer to
There is grass blockage in the cutting deck. Refer to
the product on page 17 .
Transportation, storage and disposal
To examine the blades on page
To get a good cutting result on page 15 .
Symbols on the product on page 3 .
To prevent tacky particles during storage, add a
stabilizer. If alkylate gasoline is used, stabilizer is
not necessary. If you use standard gasoline, do
not change to alkylate gasoline. This can cause
sensitive rubber parts to become hard. Add stabilizer
to the fuel in the tank or in the container used for
storage. Always use the mixing ratios given by the
manufacturer. Add the stabilizer and run the engine
for a minimum of 10 minutes, until the fuel flows into
the carburetor.
WARNING:
product with fuel in the tank in an indoor
location or in locations with bad airflow.
Risk of fire if fuel fumes come near
open flames, sparks, or pilot lights in
for example boilers, hot water tanks and
clothes dryers.
WARNING:
and other flammable materials from the
product to decrease the risk of fire. Let
the product become cool before you put
it in storage.
•
Clean the product, refer to
on page 17 .
To clean
Do not keep the
Remove grass, leaves
To clean the product
2333 - 001 - 16.11.2023
Publicité
