Husqvarna Xcite Z375 Manuel D'utilisation page 14

Cutting height setting
2
3
4
5
6
7
8
9
10
11
12
Transport position
To start the engine
1. Sit in the seat.
2. Set the cutting deck to the transport position.
To set the cutting deck in transport
Refer to
position or mow position on page 13 .
3. Engage the parking brake. Refer to
and disengage the parking brake on page 12 .
4. Move the throttle control (A) to ½ throttle
position.
B
A
5. Push and turn the ignition key (B) to the start
position.
6. Release the ignition key immediately when the
engine starts.
Note:
in the start position for more than 5
seconds at a time. If the engine does
not start, wait 15 seconds before you
try again.
7. Let the engine run at ½ throttle for 3–5 minutes
before you apply full throttle.
14
Cutting height, in./cm
1.75/4.4
2.0/5.1
2.25/5.7
2.5/6.4
2.75/7.0
3.0/7.6
3.25/8.3
3.5/8.9
3.75/9.5
4.0/10.2
4.25/10.8
4.5/11.4
To engage
Do not keep the ignition key
8. Push the throttle control to the full throttle
position.
To operate the product
1. Start the engine. Refer to
page 14 .
2. Disengage the parking brake. Refer to
engage and disengage the parking brake on
page 12 .
3. Carefully push the 2 control levers forward. The
product will start to move forward. The forward
speed increases the more the 2 control levers
are pushed forward.
4. Carefully pull the 2 control levers rearward. The
product will start to move rearward. The rearward
speed increases the more the 2 control levers
are pulled rearward.
5. Put the 2 control levers in neutral position to
decrease the speed and stop the product.
6. Do the steps that follow to turn left or right when
you go in a forward direction.
a) Pull the left control lever rearward in the
direction of the neutral position to make the
product turn left. The more you pull the left
control lever rearward, the more the product
will turn left.
To start the engine on
To
2333 - 001 - 16.11.2023