Publicité
Les langues disponibles
Les langues disponibles
Maintenance
Replace the foam pre-filter
4
(if equipped).
Clean the paper filter car-
5
tridge.
Examine the muffler and
spark arrester screen.
Start the engine and blades
and listen for unusual
sounds.
6
Sharpen the blades.
Replace the blades.
Replace the spark plugs.
Replace the engine oil.
Replace the engine oil filter.
Replace the fuel filter.
Replace the paper air fil-
8
ter.
To clean the product
CAUTION:
pressure washer or a steam cleaner.
Water can go into bearings and electrical
connections and cause corrosion which
causes damage to the product.
Clean the product immediately after use.
•
Do not clean hot surfaces such as the engine,
muffler and exhaust system. Wait until the
surfaces are cool, then remove the grass or dirt.
•
Before you clean with water, clean with a brush.
Remove grass and dirt on and around the
transmission, the transmission air intake, and the
engine.
•
Use running water from a hose to clean the
product. Do not use high-pressure.
•
Do not point the water at electrical components
or bearings. Detergent usually increases the
damage.
•
Use compressed air to clean the top side of the
mower deck.
4
In conditions with dust, cleaning and replacement must be done more frequently.
5
In conditions with dust, cleaning and replacement must be done more frequently.
6
Must be done by approved service agent.
7
Replace the engine oil after the first 8-10 hours of operation. During heavy load or high ambient
temperatures, replace the engine oil each 50 hours.
8
In conditions with dust, cleaning and replacement must be done more frequently.
2333 - 001 - 16.11.2023
Daily maintenance
Before
7
Do not use a high-
Do maintenance at
a minimum of 1
After
time each year
O
O
*
*
X
X
O
O
O
O
O
•
Use a water hose to clean below the cutting
deck.
•
When the product is clean, start the cutting deck
for a short period to remove remaining water.
To clean the engine and the muffler
Keep the engine and muffler free from grass cuttings
and dirt. Grass cuttings soaked in fuel or oil on the
engine can increase the fire risk and the risk that the
engine becomes too hot. Let the engine cool before
it is cleaned. Clean with water and a brush.
Grass cuttings around the muffler dry quickly and are
a fire risk. Use a brush or remove the grass cuttings
with water when the muffler is cold.
To clean the battery
Corrosion and dirt on the battery and the terminals
can cause the power of the battery to decrease.
1. Remove the battery. Refer to
install the battery on page 18 .
2. Flush the battery with water and let dry.
Maintenance interval in hours
25
100
O
O
*
X
X
X
X
O
O
O
O
O
To remove and
500
O
*
X
X
O
O
O
O
O
17
Publicité
