Replacing One Type Of Exhaust Filter With Another; Replacing The Thread Lifters; Cleaning And Care - Miele Swing H1 Série Mode D'emploi

If you wish to fit an AirClean exhaust
filter, please see "Replacing one type
of exhaust filter with another".
 Put the cover back on and close it.
Replacing one type of exhaust filter
with another
Depending on the model, your vacuum
cleaner will be fitted as standard with
one of the following exhaust filters (dia.
26):
a AirClean
b Active AirClean (SF-AA 10)
c AirClean Plus (SF-H 10)
Do not use more than one exhaust fil-
ter at a time.
When changing the filter, please
note (dia. 32)
1. If you wish to replace exhaust filter a
with filter b or c, you must com-
pletely remove the filter grille from the
cover before you install the new ex-
haust filter.
2. If you wish to replace exhaust filter b
or c with filter a, it is essential that
you also fit the filter grille* in the
cover.
* Filter grille – see "Optional ac-
cessories"
Removing/inserting the filter
grille (dia. 32)
 Grasp inside the hexagons in the filter
grille with 2 fingers and squeeze
slightly. You can then remove or in-
sert the filter grille as required.
Replacing the thread lifters (dia. 33)
(not possible on EcoTeQ Plus floor-
heads)
The thread lifters on the suction inlet to
the floorhead can be replaced. Replace
the thread lifters if the pile has worn
down.
 Lever the thread lifters from the slots.
To do so use a suitable tool, e.g. a flat
blade screwdriver.
 Fit new thread lifters.
Replacement parts are available from
your Miele dealer or from the Miele
Spare Parts Dept.

Cleaning and care


Always disconnect the vacuum
cleaner from the electrical supply be-
fore cleaning it. Switch off at the wall
socket and unplug it.
Vacuum cleaner and accessories
The vacuum cleaner and all plastic ac-
cessories can be cleaned with a propri-
etary cleaner suitable for plastic.

Do not use abrasive cleaning
agents, glass cleaning agents, all-
purpose cleaners or oil-based condi-
tioning agents!
Dust compartment
The dust compartment can, if neces-
sary, be cleaned using a dry duster,
brush or, if available, a second vacuum
cleaner to vacuum the dust out.
en
41