Publicité
Les langues disponibles
Les langues disponibles
6
equIpment
WARNING
Use only ECHO approved attachments. Serious injury may result from the use of a non approved attachment com-
bination. ECHO, INC. will not be responsible for the failure of cutting devices, attachments or accessories which
have not been tested and approved by ECHO. Read and comply with all safety instructions listed in this manual and
safety manual.
• Check unit for loose/missing nuts, bolts and screws. Tighten and/or replace as needed.
• Inspect shield for damage and ensure that the cut-off knife is securely in place. Replace if either is damaged or miss-
ing.
• Check that the cutting attachment is firmly attached and in safe operating condition.
• Check that front (loop) handle and optional shoulder/waist harness are adjusted for safe, comfortable operation. See
Assembly for proper adjustment.
• Have repairs done only by an authorized ECHO Service Dealer.
WARNING
Moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects away from all
openings.
• ALWAys stop engine, disconnect spark plug, and make sure all moving parts have come to a complete stop
before removing obstructions, clearing debris, or servicing unit.
• DO NOT start or operate unit unless all guards and protective covers are properly assembled to unit.
• NEVER reach into any opening while the engine is running. Moving parts may not be visible through openings.
WARNING
Check fuel system for leaks due to fuel tank damage, especially if the unit is dropped. If damage or leaks are found,
do not use unit, otherwise serious personal injury or property damage may occur. Have unit repaired by an autho-
rized servicing dealer before using.
e
c
mIssIon
EPA Phase 2
The emission control system for the engine is EM/TWC (Engine Modification and 3-way Catalyst) and for the fuel tank
the Control System is EVAP (Evaporative Emissions) or N (for nylon tank). Evaporative emission may be applicable to
California models only.
An Emission Control Label is located on the engine. (This is an
EXAMPLE ONLY, information on label varies by engine FAMILY).
PRODUCT EMIssION DURAbILITy (EMIssION COMPLIANCE PERIOD)
The 300 hour emission compliance period is the time span selected by the manufacturer certifying the engine emis-
sions output meets applicable emissions regulations, provided that approved maintenance procedures are followed
as listed in the Maintenance Section of this manual.
(
ontrol
eXhaust
&
evaporatIve
enGIne famIly: 9ehXs.0214Kf
emIssIon complIance perIod : 300 hrs.
thIs enGIne meets u.s. epa phase 2 emIssIon reGu-
latIons for small nonroad enGInes. refer to
oWner's manual for maIntenance specIfIcatIons
and adJustments.
)
Important enGIne InformatIon
dIsplacement: 21.2
cc
Publicité
