Publicité
Les langues disponibles
Les langues disponibles
16
aIr fIlter
Level 1.
Tools required:
25 or 50 mm (1 or 2 in.) Cleaning brush
Parts required:
REPOWER
1.
Close choke (Cold Start Position [
entering the carburetor throat when the air filter is removed. Brush
accumulated dirt from air cleaner area.
2.
Remove air filter cover. Brush dirt from inside cover.
3. Remove air filter and lightly brush debris from filter. Replace filter
if it is damaged, fuel soaked, very dirty, or the rubber sealing edges
are deformed.
4. If filter can be reused, be certain it:
• Fits tightly in the air filter cavity.
• Is installed with the original side out.
5. Install air filter cover.
NOTE
Carburetor adjustment may be needed after air filter cleaning/re-
placement.
fuel fIlter
Level 1.
Tools required:
200-250 mm (8-10 in.) length of wire with one end
bent into a hook, clean rag, funnel, and an approved
fuel container.
Parts required:
REPOWER
dANGeR
Fuel is VERy flammable. Use extreme care when mixing, storing
or handling.
1.
Use a clean rag to remove loose dirt from around fuel cap and
empty fuel tank.
2.
Use the "fuel line hook" to pull the fuel line and filter from the
tank.
3.
Remove the filter from the line and install the new filter.
AIR & FUEL FILTER KIT.
TM
]). This prevents dirt from
AIR & FUEL FILTER KIT
TM
Publicité
