Paramount DD5 Manuel Du Propriétaire page 13

OPERATING INSTRUCTIONS
OPERATING BY REMOTE CONTROL
1. Plug in your electric replace.
2. Make sure the unit's Main Power ON/OFF Switch is at the ON position. The remote control will NOT
work if the Main Power Switch is at the OFF position.
3. When operating the remote control, it must be pointed towards the front of the unit.
4. The ON/OFF button at the top left of the remote is the main ON/OFF power button (Figure 5). Press-
ing this button activates the power to the unit.
5. To activate the heater, press the HEATER button. Press and release the HEATER button to cycle
through LOW, MED, HIGH and OFF. The heater has a built-in thermostat so it will shut o automatically
once the pre-set temperature is reached. It will also turn on automatically if the room temperature
drops below the pre-set temperature.
6. To adjust the ame height and ember bed brightness, press the FLAME+ or FLAME- buttons. To in-
crease the ame height and ember bed brightness, press FLAME+ button, to decrease the ame height
and ember bed brightness, press the FLAME- button. There a
7. To turn o the replace, press the ON/OFF button once. NOTICE: This remote control must remain
within 8 meters or 26ft of the replace to be e ective.
Infrared Ray Exit
Indicator
Light
Figure 5
Remote Control For
Electric Fireplace
re nine levels of ame e ects.
Note: Make sure your batteries are fully charged
and installed correctly in your remote control.
Page 13