PROUSER IBC7500B Mode D'emploi page 12

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

The IBC battery charger will NOT start charging, without a charging mode being selected.
1. Before charging the battery, connect the output terminals of the charger to the battery. Make sure
all connections are tight and clean.
2. Make sure to choose the correct charging mode by pressing the Mode-button. A faulty selecting can
cause problems and damages to your battery and car. Please see also your car´s manual for
determining the right mode.
3. Settings are made by pressing the "MODE-button" and stepping forward by pressing the button one
step at a time, releasing the button when the required mode is reached. After a short amount of time
the charging process begins.
Stopping the Charging Process
Charging can be stopped at any time by disconnecting the supply cord.
After Charging
WARNING! Disconnect the supply before making or breaking the connections to the
battery. As the released gas is flammable, avoid naked flames, glowing or electrostatically
charged material and sparks in the vicinity of the battery. Always provide adequate
ventilation. Because of this risk of explosive gas, only connect and disconnect the battery
leads when the mains supply is disconnected.
1. Unplug charger from the mains supply
2. Disconnect the negative charging lead (BLACK) from the negative post of the battery
(marked -) or mass.
3. Disconnect the positive charging lead (RED) from the positive terminal post of the battery
(marked +).
4. Clean and store battery charger.
If the charged battery is maintainable, wait some time until the bubbling stops. Inspect the liquid in each
cell again and top up carefully with de-ionized or distilled water if necessary. Now replace the caps. Any
surplus fluid around the cell tops should be wiped off carefully as it may be acidic. Avoid getting
electrolyte on your skin or clothes. Use eye protection. Wash your hands carefully.
WARNING! Do not open or disassemble the device. Attempting to service the unit yourself
may cause the risk of electrical shock or fire. Please follow the safety instructions when
working on the device.
In a few cases , the charging process will finish very quickly, but the battery is not fully charged or does
not deliver the desired voltage or power. The reason for this case could be that the battery is broken
and needs to be replaced. If the device doesn't work at all, an internal fuse might be blown. This happens
always for a reason. Do not try to replace internal fuses yourself. The device has to be checked by the
manufacturer or by an authorized service.
12
TROUBLESHOOTING

Publicité

Table des Matières
loading

Table des Matières