Publicité
Les langues disponibles
Les langues disponibles
AIR FILTER
Level 1.
Tools required: 25-50mm (1-2 in.) medium bristle paint brush.
Parts required: 90008 REPOWER
1. Close choke (Cold Start Position). This prevents dirt from entering
the carburetor throat when the air filter is removed. Brush accumu-
lated dirt from the air cleaner area.
2. Remove the air cleaner cover. Clean and inspect the element for
damage. If element is fuel soaked and very dirty, replace.
3. If element can be cleaned and reused, be certain it:
-still seals the cavity in the air cleaner cover.
-is installed with the original side out.
NOTE
Carburetor adjustment may be needed after air filter cleaning/
replacement. See Carburetor Adjustment Section.
FUEL FILTER
Level 1.
Tools required: Fuel line hook. 200-250mm (8-10 in.) length of wire
with one end bent into a hook. Clean rag, funnel, and
an approved fuel container.
Parts required: 90008 REPOWER
WARNING
Fuel is VERY flammable. Use extreme care when mixing, storing or
handling, or serious personal injury may result.
1. Use a clean rag to remove loose dirt from around fuel cap and
empty fuel tank.
2. Use the "fuel line hook" to pull the fuel line and filter (A) from the
tank.
3. Remove the filter (A) from the line and install the new filter.
All manuals and user guides at all-guides.com
TM
AIR & FUEL FILTER KIT.
TM
AIR & FUEL FILTER KIT
DANGER
T
/C
ILLER
ULTIVATOR
O
'
M
PERATOR
S
ANUAL
15
Publicité
