Publicité
BASIC SHREDDING OPERATION
PAPER/CARD
1
Continuous operation:
Up to 5 minutes maximum
NOTE: Shredder runs briefly
after each pass to clear entry.
Set to Auto-On (I)
Continuous operation beyond
5-minutes will trigger
20-minute cool down period.
ADVANCED PRODUCT FEATURES
SAFESENSE
TECHNOLOGY OPERATION
®
Stops shredding immediately when hands touch the paper opening.
SET-UP AND TESTING
1
2
Press Auto-On (I)
Touch test area and
look for the SafeSense
indicator to illuminate
For more information about all of Fellowes Advanced Product Features go to www.fellowes.com
PRODUCT MAINTENANCE
OILING SHREDDER
All cross-cut shredders require oil for peak performance.
If not oiled, a machine may experience diminished
sheet capacity, intrusive noise when shredding and could
ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty
your waste bin.
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
TROUBLESHOOTING
Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This indicator
will remain illuminated and the shredder will not operate for the duration of the recovery time. See Basic Shredding Operation for more information about the continuous
operation and recovery time for this shredder.
SafeSense
Indicator: If hands are too close to the paper entry, the SafeSense
®
PAPER JAM
1
2
Set to Reverse (R)
Alternate slowly back and forth
for 2-3 seconds
All manuals and user guides at all-guides.com
2
3
Feed paper/card
When finished shredding
straight into paper
set to OFF ( )
entry and release
3
SafeSense
is active and
®
working properly
®
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1
Set to Off (O)
3
4
Set to Off (O)
and unplug
2
3
Set to Reverse (R)
* Apply oil
2-3 seconds
across entry
indicator will illuminate and the shredder will stop shredding.
®
5
6
Set to Auto-On (I) and
resume shredding
3
Publicité
