Publicité
Les langues disponibles
Les langues disponibles
remove end cap
from holdup.
Using a flathead screwdriver, remove
the end cap from the holdUp.
Install maIn Bolt.
attach fIrst traY to Base.
Align holes in base to holes in tray.
• Insert bolt, lock-
washer, and washer,
in order shown.
• Tighten with supplied
wrench.
1033534A-2/18
All manuals and user guides at all-guides.com
Insert plus2 Base Into holdup.
Align
• Insert bolt, and
lock-washer in
order shown.
• Tighten with
adjustable
wrench.
rotate to uprIght posItIon.
• Pull spring pin to
release base.
• Lift frame.
• Release spring pin. Pin
should snap into place.
pivot arm
IMPORTANT: Wheel strap is
to your right, and pivot arm is
Insert the Plus2 base
into the holdUp tube,
aligning holes.
wheel strap
LowEr TrAY:
to your left.
Publicité
