LG Multi V ARNU48GTMC2 Mode D'emploi page 8

Operating Instructions
Name and function of wireless remote controller(Accessory)
1
2
3
4
5
6
7
8
9
PQWRCQ0FDB
PQWRHQ0FDB
Operation Mode
Cooling Mode
Auto Mode or Auto Changeover
Dehumidification mode
Fan Mode
• Cooling Model( ), Heat Pump Model(
CAUTION:
Some kinds of function could not operate.
8 Indoor Unit
10
11
12
13
14
15
16
17
(Cooling only)
(Heat pump)
Heating Mode
)
When it dose not use the PQWRCQ0FDB/PQWRHQ0FDB,
1. VANE ANGLE Button
Used to set each vane angle.
2. FUNCTION SETTING Button
Used to set or clear Auto Clean, Smart Clean,
Electric heater or Individual vane angle control.
3. ON/OFF Button
Used to turn on/off the unit.
4. JET COOL Button
Speed cooling operates super high fan speed.
5. LEFT/RIGHT AIRFLOW Button (OPTIONAL)
Used to set the desired left/right(horizontal)
airflow direction.
6. UP/DOWN AIRFLOW Button
Used to stop or start louver movement and set
the desired up/down airflow direction.
7. ON TIMER Button
Used to set the time of starting operation.
8. SLEEP TIMER Button
Used to set the time of sleeping operation.
9. SET / CLEAR Button
Used to set/clear the timer.
Used to set the current time(if it input for 3sec.)
10. PLASMA Button (OPTIONAL)
Used to start or stop the plasma-purification
function.
11. ROOM TEMPERATURE SETTING Button
Used to select the room temperature.
12. OPERATION MODE SELECTION Button
Used to select the operation mode.
13. INDOOR FAN SPEED SELECTION Button
Used to select fan speed in four steps low,
medium, high and chaos.
14. ROOM TEMPERATURE CHECKING Button
Used to check the room temperature.
15. OFF TIMER Button
Used to set the time of stopping operation.
16. TIMER SETTING(Up/Down)/LIGHT Button
Used to set the timer.
Used to adjust the brightness.(if it is not time
adjust mode)
17. RESET Button
Used to reset the remote controller.