FoodSaver FM5400 Serie Manuel Du Propriétaire page 7

4. Use Pulse Vac Control Feature
Use the Pulse Vac Control feature to manually control the vacuum process and avoid crushing delicate
items.
1. Place item(s) in bag, allowing at least three inches (7.62 cm) of space between bag contents
and top of bag.
2. Press the Pulse Vac button. This will cause the "Vacuum" light to illuminate.
3. Insert open end of the bag into the Vacuum View Window until it is just inside of the Drip
Tray. Then Press Seal activation bar to close the window.
4. Press the Pulse Vac Button. The vacuum pump will run when the Pulse Vac Button is held
down. Release the Pulse Vac Button to stop the vacuum process. This will allow you to adjust
the contents of the bag for better control of the vacuum sealing process. Repeat pushing the
Pulse Vac Button until desired amount of air has been removed.
NOTE: If the vacuum pump stops engaging after several pushes of the Pulse Vac Button,
it means the maximum vacuum has been reached. Do not continue to push the Pulse Vac
Button. The bag will be sealed automatically if you reach max vacuum.
5. Press Seal Button to seal the bag and end the Pulse Vac mode.
6. When the red Seal Indicator light turns off, remove bag. Refrigerate or freeze if needed.
11 US: www.FoodSaver.com | CA: www.FoodSaver.ca | MX: www.oster.com.mx/foodsaver
FM5400_22EFSM1.indd 11-12 FM5400_22EFSM1.indd 11-12
5. Vacuum Seal with FoodSaver
PULL Retractable Handheld Sealer from
B
appliance.
For Zipper Bags
1. Prepare Zipper Bags according to FoodSaver
Accessory Guidelines, which are included with
accessory purchases.
For zipper bags, make sure not to put any
food under the valve and press zipper closed
with finger while bag is lying down on a flat
surface.
2. Press Power Button. Light will illuminate to
indicate power is on.
3. Place end of Retractable Handheld Sealer over
zipper bag valve.
4. Press Accessory button to vacuum.
Zipper Bags are safe for pantry and fridge use only.
For Jar Sealers & Bottle Stoppers
1. Prepare accessory according to FoodSaver
Accessory Guidelines, which are included with
accessory purchases.
2. Press power button. Light will illuminate to
indicate power is on.
3. Remove clear bottom portion of Retractable
Handheld Sealer from top handle. Insert the
tip into the port on the Jar Sealer or Bottle
Stopper.
4. Press Accessory button to vacuum.
Note: FoodSaver Jar Sealers are for use with Ball
®
Important: Do not include screw bands when vacuum sealing jars. To open, wedge spoon
between Mason jar lid and highest part of threaded rim. Twist spoon gently to release vacuum.
FoodSaver ® Bottle Stoppers: To release vacuum and open, twist and pull up on Bottle Stopper.
Consumer Service: US: 1-877-777-8042 CA: 1-877-804-5383 MX: +52 55 5366 0800
Accessories
®
B
®
®
and Kerr brand Mason jars only.
® ®
2022/1/27 2:45 PM 2022/1/27 2:45 PM
12