HoMedics MCS-1600H-EU Manuel D'instructions page 3

PRODUCT FEATURES: Unique SensaTouch nodes provide a smooth, natural touch massage
1
2
3
4
INSTRUCTIONS FOR USE:
IMPORTANT - Preparing the appliance for use
The Shiatsu Massager comes with a screw located on the back of the unit to
protect the massage mechanism during shipment, which must be removed
before the first use to allow the shiatsu feature to function. Use the provided
Allen key. Then, properly dispose of the screw.
WARNING Failure to remove screw may cause permanent damage to
the appliance.
Error: all remote control LEDS flash for a few seconds.
Cause: massager overloaded.
Solution: ensure the allen key bolt/screw has been removed from back of the
massage cushion (using the allen key included). Should the condition continue
after this please contact your HoMedics service centre.
Strapping System
The SensaTouch 2 in 1 Shiatsu Back and Shoulder Massager incorporates a
unique strapping system which allows you to fasten it to almost any chair. Just
slip the straps over the seat or chair and adjust fastening straps to secure. Your
massager won't slip or slide away.
Note: Do not use this product for more than 15 mins at a time.
There is a 15 minute auto shut-off on this appliance for your safety. This feature
should not be considered as a substitute for 'OFF'. Always remember to switch
the appliance off when not in use.
1 Demo Button – For a brief demonstration of the features
of the Shiatsu Massaging Cushion, press the Demo button.
The unit will briefly go through each function. Once complete,
the unit automatically turns off. The L.E.D. light will blink to
5
indicate the active functions.
Shiatsu Massage – A deeply relaxing and rejuvenating
experience invented in Japan using rhythmic finger pressure to
stimulate 'chi' (vital energy), relieving stress and tension.
2 Shiatsu Programs – Choose from 3 preset programs
where the Shiatsu massage travels up and down in a specific
area of the back. To select a program, simply press the button
and the LED will illuminate. To deselect, press the button again
or press another button.
= Full Back
= Upper Back
= Lower Back
3 Spot Shiatsu – While the unit is in Shiatsu massage,
6
press either button to stop and focus the Shiatsu action in
7
one place. Once the unit is operating in Spot Shiatsu, you may
adjust the mechanism position by holding down either button
until the desired position is reached. The Up Arrow will move
the mechanism upwards and the Down Arrow will move it
down. Once you release the button, the mechanism will stop
in that place.
8
4 Power Button – To turn on the unit, first press the
POWER button. The LED indicator will illuminate and confirm
your selection. To turn off the unit, simply press the button
again. The LED indicator will blink while the back massage
mechanism returns to its lowest point and then it will turn off.
5 Shiatsu Shoulder Massage – Press the shoulder
button to activate. Adjust the height of the mechanism to meet
your shoulders using and buttons. For soothing heat press
the heat button.
6 Width Adjustment – While the unit is in Rolling
massage for the back, press this button to adjust the distance
or width between the massage heads. With each press, the
massage heads will move to the next available position.
3
Rolling Massage Rolling is like two hands or thumbs working
up and down your back.
7 Rolling Programs
where the Rolling massage travels up and down in a specific
area of the back. To select a program, simply press the button
and the LED will illuminate. To deselect, press the button again
or press another button.
8 Heat – For soothing heat when massage is on, simply
press the heat button and the corresponding red L.E.D. light
will illuminate. To deselect, press the button again and the
corresponding L.E.D. light will turn off. For your safety, heat
cannot be turned on if massage is not selected.
NOTE The moving dual massage mechanism on the back
always "parks" or finishes in its lowest position. It will
continue to this position after the power has been turned
off. If the electrical supply is interrupted, when power is
restored, the mechanism will "park" or move to its lowest
position.
Shoulder SensaTouch
Shiatsu massage
Back SensaTouch Shiatsu
massage mechanism
The actual product materials and fabrics may vary from the
picture shown
MAINTENANCE:
Cleaning
Unplug the appliance and allow to cool before cleaning. Clean only with a soft,
slightly damp sponge.
• Never allow water or any other liquids to come into contact with the appliance.
• Do not immerse in any liquid to clean.
• Never use abrasive cleaners, brushes, glass / furniture polish, paint thinner etc
to clean.
Storage
Place the appliance in its box or
in a safe, dry, cool place. Avoid
contact with sharp edges or
pointed objects which might cut
or puncture the fabric surface. To
avoid breakage, DO NOT wrap the
power cord around the appliance.
DO NOT hang the unit by the cord.
Easy storage
– Choose from 3 preset programs