Start - Maruyama MS074 Manuel Du Propriétaire

Start

Start of engine
CAUTION
When starting the engine, make sure to put water
or chemicals into the chemical tank. Without
water or chemicals in the tank, the pump will break
down.
1
Perform priming.Push priming pump installed
in front of the carburetor (rear in the specifi-
cation with cell starter) several times slowly,
and confirm that fuel fills the priming pump
and returns to the tank.
English
2
Fully close the choke. (In hot weather or
when engine is hot, the choke should be
partly open or fully open.)
Close
3
Move throttle lever to medium-and low-
speed position.
4
Set handle of pressure control valve at
"Start" position.
Start
11
5
Engine will start.
After pulling starting rope gently by two or
three times, pull it hard to start the engine.
[Pulling method for starting rope]
1. Grasp starting rope tight with right hand.
2. Hold chemical tank with left hand.
3. Pull starting rope slowly until resistance is felt.
4. Pull starting rope straight from entrance of
starter.
5. Do not pull starting rope to the end.
6. Don't release starting rope from pulled state,
and let it return to its original state gradually.
CAUTION
If the engine does not start by repeated action,
try pulling the rope after fully opening the choke.
※ If the engine still does not start, refer to
page 17.
Starter rope
Recoil Starter
6
Return choke slowly.
Open
CAUTION
・Frequent operation of choke when starting the
engine causes too much fuel to be sucked in,
making the engine difficult to start. In that
case, start after making the choke fully open.
・After starting the engine, accelerate bit by bit
quickly by opening and closing the throttle
lever several times.
・This operation is to bleed air in the carburetor.
When there is air present, there is the possi-
bility of poor acceleration and engine stalling.
・Supply fuel prior to use if possible. This will
make starting next time easy.
12
English