Publicité
Les langues disponibles
Les langues disponibles
C. Operation general
1.
Check the heater for damage or defects. Do not use a damaged heater, but contact
your supplier.
2.
Make sure to use undamaged, full gas bottles with propane or butane, suitable for
use.
3.
Select a place for the heater that meets all the safety instructions and place it on a
level, stable, horizontal surface with non-flammable material. Do not plug it in and
the set the power switch to O (off).
4.
Firmly attach the gas hose with suitable tools to the pressure regulator (left screw
threads!).
5.
Remove the protective cap and attach the gas supply hose to the device (left screw
threads!). Firmly screw on the nut with suitable tools for unproblematic gas supply.
6.
Connect the pressure regulator to the gas bottle. Firmly screw the nut on so that no
gas leakage can occur. Make sure when you install the gas bottle that the gas hose is
not bent or kinked. Avoid turned and pulled tension.
7.
Check that the device is correctly attached to the gas bottle and perform a complete
gas leakage test (see the description below in this booklet).
8.
When you're sure everything is in order, open the gas tap. (Diagram 1).
9.
Now insert the plug into the socket. Then set the power switch to I (on) (Diagram 2).
The ventilator will start running.
10. Wait until the ventilator is running steadily and stable. Now press the right-hand
button of the gas valve and keep it pressed down for 10 seconds. Then with your left
hand simultaneously press the ignition button a few times to ignite the device
(Diagram 3).
11. After the gas starts burning, keep the gas valve pressed in for another 15 seconds.
After that, you can let go and the gas will burn continuously (Diagram 4).
12. To switch off the device, close the gas tap of the gas bottle and wait until the flame
goes out. Now switch the power switch to O (off) and remove the plug from the
socket. Finally, disconnect the pressure regulator from the gas bottle.
Attention! The device will remain hot for a while after use. Always remove the plug
from the socket when the unit is not in use.
13. If you have to change the gas bottle or want to use the device after a period of
storage, you must repeat the entire process, including the gas leakage test.
Attention: If you have tried to start the device according to the procedure described
above and that does not work after three attempts to ignite it, don't try it again. Due to
the high gas concentration, there is now an explosion hazard! Contact your dealer to
find out the reason for the malfunction. Make sure when you install the gas bottle that
21
Publicité
