Publicité
Les langues disponibles
Les langues disponibles
Operation
A. How do I safely connect a (new) gas bottle to my Eurom patio heater?
Uncouple the old gas bottle
1. Switch off the patio heater with the control knob and close the gas tap on top of the
gas bottle by hand. Even with an empty gas bottle. (Note: turn closed = turn clockwise)
2. Let the patio heater cool down for at least 15 minutes. After 15 minutes, check that
there are no glowing parts anywhere.
3. Disconnect the pressure regulator from the old gas bottle by hand, (preferably) do not
use any tools. (Note: unscrew = turn clockwise)
Couple a new gas bottle
1. Keep all possible ignition sources away. Think e.g. open flames, sparks, cigarettes, hot
surfaces, electrical equipment, etc.
2. Take measures to prevent the creation of electrostatic charges.
3. Avoid sparks from iron on iron.
4. Check whether the black sealing rubber is present in the union nut of the pressure
regulator and is in good condition.
5. Connect the pressure regulator to the gas bottle. Tighten the union nut firmly by hand,
sufficient to obtain a gas-tight connection. (Note: tighten = turn counterclockwise).
6. Open the gas tap on top of the gas bottle. (Note: turn open = turn counterclockwise).
7. When you hear a hiss, immediately close the gas tap on top of the gas bottle. The
connection is then not closed. Tighten the union nut of the pressure regulator.
8. Do a leak test with soap water. When soap bubbles form, the connection is not closed.
Immediately close the gas tap on top of the gas bottle. Tighten the union nut of the
pressure regulator.
9. If no leakage has been detected, you can ignite the patio heater.
B. Before using
ALWAYS use wrenches for a gastight connection.
Skip step 1 if the gas hose/gas pressure regulator connection was already made during
manufacture.
1. Connection gas hose /gas pressure regulation, use wrenches 19 and 18.
2. Connection gas hose/gas heater, use socket wrench 17.
3. Check all connections on gas leakage with soapy water (also the connection of the gas
hose/gas pressure regulator that may have already been made during manufacture).
1
2
20
3
Publicité
