Electrical hazard
Electrical equipment in the pump includes live parts which, upon contact, can cause serious damage to persons and
property. Any kind of intervention on the electrical system must be performed by qualified personnel.
Fire hazard
Use of the pump for any uses not provided for or prohibited by this manual as well as a lack of proper maintenance
can cause malfunction with a risk of overheating and fire.
In case of fire, do not use water to extinguish the flames, but use dry chemical or CO2 or other means compatible
with the presence of electrical equipment and lubricants.
Slip and fall hazards
The "L" series vacuum pumps use lubricant to operate. A simple maintenance or improper use not complying with
the instructions included in this manual can damage the gaskets and/or seals and cause the lubricant to spill on the
floor constituting slip and/or fall hazards for personnel.
Entanglement hazard
There is a permanent impending hazard of entangling or entrapping hair and clothing in the cooler fan inside the
guard near the fan casing on the electric motor. Tie long hair up and do not wear baggy clothing, long laces or other
items that could get caught up.
Part projection hazard
Install the pump in order to avoid those in charge of works being directly hit by parts or bits of parts flying through
the fan cover casing due to the cooling fan breaking.
2.3
PICTOGRAMS
Pictographs with the warning symbols and safety symbols for operators have been applied to the pump. Read
carefully and take note of the symbols and their messages before using the pump.
ELECTRICAL HAZARD
The pump is near electrical connections (protected) but where accidental contact can cause
electric shock and death.
HOT SURFACE HAZARD
The pump is close to surfaces with temperatures exceeding 70°C which may lead to burns of
medium severity.
REFER TO INSTRUCTION MANUAL/BOOKLET
Before use read the instructions in the operating manual.
D.V.P. Vacuum Technology s.p.a. disclaims any liability for damage to persons or property due to non-compliance
with instructions indicated in pictograms or their improper preservation.
8702036 – 12/04/2016 – R.7
Operating and Maintenance Instructions
LC.2 – LC.4 – LB.5 – LB.6 – LB.8 – LC.12 – LC.20
4
EN
www.dvp.it