Hilti TE 700-AVR Mode D'emploi page 20

Trouble or fault
The breaker doesn't
achieve full power.
The chisel cannot
be released from the
chuck.
10 Disposal
Most of the materials from which Hilti tools and appliances are manu-
factured can be recycled. The materials must be correctly separated before
they can be recycled. In many countries, your old tools, machines or appli-
ances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti
representative for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as
household waste!
11 Manufacturer's warranty
▶ Please contact your local Hilti representative if you have questions about
the warranty conditions.
Mode d'emploi original
1 Indications relatives au mode d'emploi
1.1 À propos de ce mode d'emploi
• Avant de mettre l'appareil en marche, lire impérativement ce mode
d'emploi. C'est la condition préalablement requise pour assurer la
sécurité du travail et un maniement sans perturbations.
14 Français
Possible cause
Power reduction is ac-
tive.
The extension cord is
too long or its gauge is
inadequate.
The voltage provided by
the electric supply is too
low.
The chuck is not pulled
back fully.
Action to be taken
▶ Press the power level
selector switch (ob-
serve the power level
indicator). Unplug the
power tool from the
electric supply and
then plug it back in.
▶ Use an extension cord
of an approved length
and / or of adequate
gauge.
▶ Connect the power
tool to a different
power source.
▶ Pull the tool lock back
as far as it will go and
remove the insert tool.
428076
*428076*