Aerus LUX LEGACY C153E Mode D'emploi page 5

Les langues disponibles

OPERATION

CAUTION:

Turn the cleaner off before connecting or disconnecting wands, power nozzle and hose.

TO CONNECT THE POWER CORD (H):

• Pull the cord out to the length required and let cord retract slowly until the reel lock engages; a yellow

band on the power cord indicates the limit of extension; do not pull the cord beyond that point

• Connect the plug into wall outlet; the control light should come on to indicate that power is available

• The cordwinder automatically rewinds the cord when given a light tug; hold onto the plug, feed the

power cord slowly into the unit; do not allow the cord to whip into cordwinder

TO START THE CLEANER:

• Gently press the toe switch (I) on top of the unit

• To stop the machine, press the toe switch again; always switch the cleaner OFF before disconnecting

power cord

CLEANING WITH THE POWER NOZZLE:

Use the power nozzle for every type of dry floor cleaning. The power nozzle's self adjusting action adapts to

different carpet heights as well as hard surface floors. It maneuvers easily around furniture and right up to

walls, providing superior edge cleaning and two-sided corner cleaning.

TO START THE POWER NOZZLE:

• The power nozzle control switch (J) is located on top of the hose hand grip and has two positions

• Setting the switch to "I" engages the high speed brush to dig up embedded grit from carpets and whisk

up dust and dirt from hard surface floors

• To clean delicate antique rugs or highly polished parquet floors, set the switch to "O"; the brush disengages

and only the cleaner's suction is used

IF AN OBJECT BECOMES CAUGHT IN THE POWER NOZZLE, IT WILL AUTOMATICALLY SHUT OFF.

• Turn the power nozzle switch (J) and the cleaner OFF

• If the object is caught in the brush, turn the power nozzle over and gently remove the caught object from

the brush (K)

• If the object is caught further in the unit, detach the wand and remove the object through the elbow (L)

• Reattach the wand

• Push the reset (M) switch located on the power nozzle top and release to reset

All manuals and user guides at all-guides.com