Publicité
Les langues disponibles
Les langues disponibles
Step 3: Charge the Battery before your first use.
You MUST charge the Battery for twenty-four (24) to seventy-two (72) hours before you use the Mower for the first time. If you
do not charge it before using the Mower, the Battery's charging capacity may decrease.
For instructions on charging the Battery, read "Chapter 4: Charging and Caring for the Battery".
Step 4: Attach the Lower Handlebar Sections
To keep the Mower from moving while you assemble it, place your foot behind one of the wheels.
TIP
NOTE: You will use the green Quick-Connect Knobs to attach the Lower Handlebar sections to the Mower. Install both
handlebars the same way.
1. Set the Cutting Height Lever (Figure 3) to the highest adjustment (position 6 – Lever all the way down). This makes it
easier to reach the slots on the Mower frame.
Cutting Height Lever
(Adjust all the way down.)
2.
Position the Lower Handlebar with the smooth side against the frame of the Mower. Slide it down fully into the slot on the
frame until the holes line up.
NOTE 1: Place the Lower Handlebar with the cord clip on the right side (viewed from the Operator's position behind the Handlebar) of
the Mower.
NOTE 2: Be sure you slide the Handlebar all the way down to the bottom of the slot. When you do this, the cutout notch on the end of
the Handlebar aligns with the base of the channel in the Mower's frame.
3.
Insert a green Quick-Connect Knob with a Lock Washer through the lined-up holes on the Handlebar and Mower Frame.
Turn the Knob clockwise until firmly snug. Repeat this step for the other side.
Be sure to tighten the green Quick-Connect Knobs by hand. Do not use a tool to tighten them; you could easily over tighten
them and damage the parts.
Step 5: Attach the Upper Handlebar Assembly
NOTE: You will use the black Connector Knobs and Bolts (already
attached to the Lower Handlebars) to connect the Upper and
Lower Handlebar sections together.
1.
Remove the black Connector Knobs and Connector Bolts from
the upper ends of the Lower Handlebars.
Let the Upper Handlebar Assembly lean on the ground
during this process (Figure 4). It is easier to start with the
TIP
Upper Assembly in this position, so you don't have to
hold and balance it while connecting the sections. Once
you have the Handlebars loosely connected, you can
swing the Upper Assembly into place and tighten it
further (Figure 5) on page 7.
6
All manuals and user guides at all-guides.com
Figure 3
Lower
Handlebar
Handlebar
Cable
Connector
Green Quick-
Connect Knob
Upper Handlebar in a position
for ease of attachment.
(shown already attached)
Figure 4
Upper
Handlebar
www.neutonpower.com
Publicité
