Publicité
Les langues disponibles
Les langues disponibles
Installing the Bagger
1.
Raise the Discharge Guard on your Mower (Figure 13) and
note the metal Support Rod at the rear of the Mower.
2.
Grasp the Bagger by the Top Handle (Figure 14) and center
it at the back of the Mower.
3. Align the Metal Latch Hooks (Figure 14) over the Support
Rod (Figure 15) and lower the Bagger in place until the Wire
Frame at the bottom of the Bagger rests on the Mower.
4.
Lower the Discharge Guard.
Removing and Emptying the Bagger
1.
Raise the Discharge Guard.
2.
Using the Top Handle of the Bagger, lift the Bagger off the
Support Rod and away from the Mower.
3.
Lower the Discharge Guard.
4.
To empty the Bagger, tilt the Top Handle forward. Use the
Cloth Handle (Figure 12) at the rear of the Bagger to move
the contents toward the front as you empty the Bagger.
Step 6: Insert the Battery after being fully charged.
1.
Orient the Battery with the indentations on the bottom of
the Battery lining up with the metal tabs in the bottom of
the Battery compartment.
2.
After confirming the correct orientation of the Battery, insert
the Battery fully into the Battery compartment.
3.
Turn the Battery Retainer Arm back over on top of the
Battery to secure it in place (Figure 2 on page 5).
NOTE: If the Battery is not oriented correctly, it will not fully depress
into the opening. If this happens, remove the Battery,
recheck the orientation, and try again.
Figure 16
NEUTON CE 5.3 Battery-Powered Mower -
All manuals and user guides at all-guides.com
Support Rod
Cloth Handle
Safety & Operating Instructions
Discharge
Guard
Figure 13
Top
Handle
Figure 14
Latch Hook
Figure 15
Support Rod
Latch Hooks
9
Publicité
