Publicité
Les langues disponibles
Les langues disponibles
6. Wiring.
CAUTION: Be sure outlet box is properly grounded
and that a ground wire (GREEN or Bare) is present.
Make sure all electrical connections comply with
Local Codes or Ordinances and the National
Electrical Code. If you are unfamiliar with electrical
wiring or if the house/building wires are different
colors than those referred to in the diagram to the
right, please use a qualified electrician.
When downrod is secured in place on the
hanging bracket, wire the RECEIVER with wire
connectors provided as shown in diagram at
right.
Tip: While you are wiring, keep in mind that
wires must not obstruct receiver from sliding
into hanging bracket.
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
Gently insert receiver (flat side up) into hanging
bracket and carefully push wires and taped wire
connectors into outlet box. Let antenna rest
outside of hanging bracket.
IN ORDER TO WIRE WALL CONTROL, remove
existing wall switch. Wire the WALL CONTROL with
wire connectors provided as shown in diagram at
right.
* Wrap each wire connector separately with
electrical tape as an extra safety measure. Gently
push wires and taped wire connectors into outlet
box.
Use a ballpoint pen or a small screwdriver to set the
code switches 1 through 4 on the wall control.
Factory setting is pre-set and not recommended for
use. Write down number sequence for use in Section 11.
Locate the dimmer switch to the right of the code
switches labled "D" and "X". Set the dimmer switch
to ON (D) position only if using incandescent bulbs.
Set the dimmer switch to OFF (X) position if using
compact fluorescent bulbs.
NOTE: Most compact fluorescent bulbs are not
compatible for use with dimmer switch.
Attach wall control to outlet box and secure with
screws from original wall switch. Attach front plate to
wall control using 2 screws provided in the wall
control.
All manuals and user guides at all-guides.com
page 6
white supply wire
black supply wire
blue
orange
white
black
from fan
from receiver
black
white
orange
blue
receiver
(wiring for receiver)
outlet box
green/
green/
green/
bare
bare
bare
ground
ground
ground
green
black (OUT to fan)
black
black
(TO POWER supply)
black
(AC IN from
breaker box)
(wiring for wall control)
ground (green
or bare)
black
from ceiling
from receiver
black
AC IN L
white
AC IN N
antenna
wall
control
plate
code
switches
dimmer
switch
Publicité
