5. Fan Assembly.
If you wish to extend the hanging length of your
fan, you must remove the hanging ball from the
12in. downrod provided to use with an extended
downrod (sold separately). [If you wish to use the
12in. downrod, please proceed to instructions
following the dotted line below.]
To remove hanging ball, loosen set screw on
hanging ball, lower hanging ball and remove stop
pin. Slide hanging ball off the original downrod, A,
and slide it down the longer downrod, B (the top of
the downrod should be noted as having a set screw
hole; use this hole when setting the set screw).
Insert stop pin into top of extended downrod and
raise hanging ball. Be sure stop pin aligns with slots
on the inside of the hanging ball. Tighten set screw
securely.
Tip: To prepare for threading electrical wires
through downrod, apply a small piece of electrical
tape to the ends of the electrical wires--this will
keep the wires together when threading them
through the downrod.
Locate canopy cover in hardware pack. Loosen yoke
set screws and nuts in motor housing yoke and
remove pin and clip from motor housing yoke. Slide
downrod through canopy, canopy cover, scroll arm
support and yoke cover. [Note: Canopy cover must
be turned with shiny side toward the motor
housing.]
Thread safety cable and electrical wires through
downrod and pull extra wire slack from the upper
end of the downrod.
Place downrod into the motor housing yoke and
re-insert pin and clip. Securely tighten yoke set
screws and nuts. Lower yoke cover to motor
assembly.
["Fan Assembly" continued on next page.]
NOTE: The important safety precautions and
instructions appearing in the manual are not meant to
cover all possible conditions and situations that may
occur. It must be understood that common sense and
caution are necessary factors in the installation and
operation of this fan.
All manuals and user guides at all-guides.com
page 4
set screw
stop pin
hanging ball
A
electrical wiring
canopy
clip
set screw hole
B
safety cable
downrod
canopy cover
scroll arm
support
yoke cover
yoke set screw
and nut
pin
motor assembly