Publicité
Les langues disponibles
Les langues disponibles
Electrical Requirements:
Provide a 115 volt, 60 cycle, single phase 15 amp, AC re-
ceptacle. It is recommended that a separately fused circuit
(a time delay fuse or circuit breaker is recommended),
serving only this appliance, be provided. Electrical opening
should be placed 78
⁄
" (199.4cm) minimum from the floor.
1
2
(See Figure 4).
This product is factory equipped with a power supply
cord that has a three-pronged, grounded plug. It must be
plugged into a mating grounding type receptacle in ac-
cordance with the National Electrical Code and applicable
local codes and ordinances. If the circuit does not have a
grounding type receptacle, it is the responsibility and obli-
gation of the customer to provide the proper power supply.
The unit must be installed according to your local building
codes and ordinances.
WARNING
!
Electrical Shock Hazard
• Do not use an extension cord with this appliance.
They can be hazardous and cause deficient
operation.
• This unit should not, under any circumstances, be
installed to an un-grounded electrical supply.
• Do not remove the grounding prong from the
power cord.
• Do not use an adapter.
• Do not splash or spray water from a hose on
the appliance. Doing so may cause an electrical
shock, which may result in severe injury or death.
All manuals and user guides at all-guides.com
PRE INSTALLATION CONSIDERATIONS
Plumbing Requirements:
Ice maker water supply line,
copper tubing to come up the rear of cut out opening ap-
proximately 78" (198.1cm) off the floor depending on height
adjustment. Tubing should then pass around the right side
of the power module and around the front to the water sole-
noid valve. (See Figure 5).
When installing the water line for the ice maker, be sure
to install a SHUT-OFF VALVE at a convenient location
between the freezer and the supply line. Required water
pressure range is 20 to 120 psi (138 to 827 kPa).
Also recommended is an in-line WATER FILTER between
the freezer and the supply line to prevent sediment from
blocking water flow through the water solenoid valve.
An ideal location for these items is on top of the cabinet,
behind the grill, and to the right of the power module.
NOTE
Self-piercing water valves and plastic tubing are NOT ap-
proved for water supply to ice maker.
8
⁄
" (6.4mm) outside diameter
1
4
Publicité
