Publicité
Les langues disponibles
Les langues disponibles
Anti-tip Bracket considerations
Before placing the cabinet in opening, the depth of the
cut-out opening should be at least 24 inches. If the cut-
out opening depth is more than 24 inches, then a piece of
wood must be secured crosswise on the wall into the studs
at the height of the anti-tip brackets. (See Figure 9 and 11).
Slide the cabinet into position and level the cabinet with
adjustable rear roller and front leveling legs. (See Leveling
the unit on page 11).
24" wide refrigerator/freezer:
The anti tip bracket is fastened to the cabinet and runs the
full width of the cabinet. Locate a wall stud behind the cabi-
net and secure the anti-tip bracket with at least (2) #8 x 1
screws provided. See Figure 8.
30" and 36" wide refrigerator/freezer:
Locate a wall stud behind the unit that is suitable for secur-
ing the 5" anti-tip bracket to the wall. The position of the
bracket should be to the right of the power module and not
behind the power module. Do not disturb the power module
gasket on the left side of the unit. Place the anti tip bracket
on top of the cabinet flush with the back of the cabinet.
Mark and drill at least three holes (1/8" (3.2mm) into the
top of the cabinet and secure the bracket to the top of the
cabinet with at least (3) of the #8 x
cure the bracket to the wall stud with at least (2) #8 x 1
screws provided. See Figure 10.
Figure 8
24" wide refrigerator/freezer
All manuals and user guides at all-guides.com
INSTALLING THE CABINET
⁄
"
1
2
⁄
" screws provided. Se-
5
8
⁄
"
1
2
-Wall stud
-Anti-tip
bracket
on top of
cabinet
-At least 2
screws into
wall stud.
10
Figure 9
24" wide refrigerator/freezer
Figure 10
30" and 36" wide
refrigerator/freezer
Crosswise
lumber-
30" and 36" wide
refrigerator/freezer
-Crosswise
lumber
-Wall stud
-Anti-tip
bracket
on top of
cabinet
-At least 2
screws into
wall stud.
Figure 11
Publicité
