Publicité
Les langues disponibles
Les langues disponibles
Remove the bottom door:
5. Remove the 2 #10 screws from the center hinge with a
5/16 wrench or socket and ratchet.
6. Pull the center hinge out of the cabinet and lift the bot-
tom door off the lower hinge.
CAUTION
!
Door panels MUST NOT exceed 50 lbs. Do NOT use glass,
mirrors, granite or similar heavy materials for panels. Pan-
els weighing more than 50 lbs. may cause product damage.
We recommend that the door load (panel and food) NOT
exceed 90 lbs.
Step 2: Size the Overlay Panel
Cut the custom overlay panel to the dimensions shown in
Figure 27 and Table D.
This is also a convenient time to locate and drill the holes
for your handle. Most often the handle is to match that of
the surrounding cabinetry. If your handle attaches from the
back-side of the custom panel, locate the mounting holes
while the panel is attached to the door and cabinet. After
the panel is removed from the door, drill the mounting holes
from the front, to the recommended diameter of the handle
manufacturer. Counter bore the back-side of the panel so
the screw heads do not interfere with the surface of the
door.
All manuals and user guides at all-guides.com
CUSTOM GRILLE FACIA AND DOOR PANELS
Door Gasket-
Figure 28
22
⁄
"
7
16
(57cm)
45
⁄
"
9
32
(115cm)
M24TF-WP
Table D
M30TF-WP
M36TF-WP
Screw-
-Solid door
-Door panel
19
"D"
Top freezer
door panel
Bottom
refrigerator
door panel
Figure 27
MODEL
"D"
22
⁄
" (56.7cm)
5
16
28
⁄
" (71.9cm)
5
16
34
⁄
" (87.2cm)
5
16
Publicité
