Hilti HDE 500-22 Mode D'emploi page 36

Trouble or fault
The product or battery gets
very hot.
The foil pack holder cannot
be swiveled into the product.
The foil pack holder does not
engage with an audible click
No mortar is dispensed from
the mixing nozzle
10 Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping gases or liquids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
Most of the materials from which Hilti products are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, your old tools, machines or appliances
can be returned to Hilti for recycling. Ask Hilti Service or your Hilti sales representative for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
11 Manufacturer's warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
12 Further information
For more information on operation,
qr.hilti.com/manual/?id=2293681&id=2293682
This link is also to be found at the end of the documentation, in the form of a QR code.
28 English
Possible cause
Electrical fault
The foil pack is not pushed fully
into the holder.
Piston rods not pulled back fully
The retaining lugs are dirty
The retaining lugs are defective
Mortar in the mixing nozzle has
hardened
Dispensing switch set to repeat
function, but dispensing quantity
not defined beforehand.
technology, environment and recycling,
Action to be taken
▶ Switch the product off immedi-
ately, remove the battery, keep
it under observation, allow it
to cool down and contact Hilti
Service.
▶ Push the foil pack into the foil
pack holder as far as it will go.
▶ Press the release button and
pull the piston rods all the way
back.
▶ Clean the retaining lugs.
▶ Insert a different foil pack
holder. Contact Hilti Service if
the problem persists.
▶ Unscrew the mixing nozzle
containing the hardened mortar
and fit a new mixing nozzle.
▶ Define a dispensing quantity
before you use the repeat
function.
follow this link:
2293681
*2293681*