Publicité
Les langues disponibles
Les langues disponibles
Using your Vac-Blower
Always check the area to be worked, for wire and other debris etc, that could cause
damage to the Vac-Blower and injury to the operator.
Never feed hard objects such as stones, bottles, cans or pieces of metal into the
Vac-Blower. They can cause damage to the machine and possibly injury to the
operator and bystanders.
Never use the machine if there are people, especially children, or animals nearby.
Never let any person who is not familiar with these instructions operate this
machine.
Avoid operating the Vac-Blower in wet conditions, wherever possible.
Know how to stop the Vac-Blower quickly in an emergency.
Never operate the Vac-Blower if any of the guards are damaged, incorrectly fitted or
missing.
Make sure that you have adopted a safe and secure operating position before using
the Vac-Blower.
Make sure that all nuts and bolts are secure before starting the Vac-Blower.
Only use the Vac-Blower in dry surroundings never outdoors in the rain.
Do not use the Vac-Blower if it has a faulty safety device or if a guard is missing.
Special care should be taken when cleaning. This should only be done with the Vac-
Blower switched off and disconnected from the mains supply to prevent injury.
Ensure that the cable and any extension cable used are checked for damage and
are coiled correctly without kinks
Remove the plug from the mains supply:
Before leaving the Vac-Blower unattended for period;
Before clearing any blockage;
Before checking, cleaning or carrying out any work.
If a foreign body, or other debris, is accidentally feed into the Vac-Blower, stop it
immediately and do not use the Vac-Blower until it has been checked and you are
sure that the entire Vac-Blower is in a safe operating condition.
If the Vac-Blower makes any unusual noise or starts to vibrate abnormally STOP
immediately remove the plug from the mains supply and investigate the cause.
Excessive vibration can cause damage to the Vac-Blower and injury to the
operator.
Operating instructions
Components and controls (Pic.1-2)
1.
Front suction tube
2.
Rear suction tube
3.
Additional handle
4.
On/Off switch
5.
collection bag
6.
Selector switch for blower/vac
7.
Wheel support
8.
Blet
9.
Power cable
EN
Publicité
