Publicité
Les langues disponibles
Les langues disponibles
EN
Disconnect Power Tools
Ensure that power tools are disconnected from the mains supply when not in use,
before servicing, lubricating or making adjustments and when changing
accessories such as blades, bits and cutters.
Remove Adjusting Keys and Wrenches
Form the habit of always checking to see that keys and adjusting wrenches are
removed from the power tool before turning it on.
Avoid Unintentional Starting
Ensure that the switch is in the OFF position before plugging the power tool into the
mains supply.
Extension Cords and Reels
The appliance should be supplied via a residual current device (RCD) with a
tripping current of not more than 30 mA.
DO NOT use 2 core extension cords reels on power tools with an earth path. Always
use a 3 core extension cord or reel with the earth core connected to earth.
When the power tool is to be used outdoors, use only extension cords intended for
outdoor use and are so marked.
Always unwind any extension cords fully.
2
For extension cords up to 15 meters use a wire cross section of 2.5mm .
For extension cords over 15 meters but less than 40 meters use a wire cross
2
section of 2.5mm .
Always replace a damaged extension cord before using it.
Protect your extension cord from sharp objects, excessive heat and damp or wet
locations.
Stay Alert
Watch what you are doing, use common sense, and do not operate the power
tool when you are tired, if taking medication that causes drowsiness, when having
consumed alcohol or taken drugs.
Check Damaged Parts
Before using the power tools it should be carefully checked to determine that it will
operate properly and perform its intended function.
Check for the correct alignment of moving parts ensuring they do not bind. Check
for broken or missing parts and have them replaced or repaired at an authorized
service center. If the power tool requires mounting make sure it is securely
attached to a suitable workbench. Check any other condition that may affect the
operation of the power tool.
A guard or any other part of the power tool that is damaged should be properly
repaired or replaced by an authorized service center unless otherwise indicated in
this instruction manual.
Any switch that does not operate correctly must be replaced by an authorized
service center.
Do not use the power tool if the ON/OFF switch does not turn the power tool ON and
OFF.
Publicité
