Publicité
Les langues disponibles
Les langues disponibles
EN
Eye Protection
The use of safety goggles is mandatory requirement (normal glasses are not
sufficient for eye protection). Prescription spectacles do not have safety lenses.
Ear Protection
Ear protection is advised during periods of extended operation.
Footwear
Where there is a risk of a heavy object damaging feet or there is a risk of slipping on
wet or slippery floors suitable non-slip safety footwear should be worn.
Head Protection
Where there is a risk of falling objects or hitting your head on protruding or low level
obstructions a hard hat should be worn.
Respiratory Protection
When the machining operating creates dust, wear a dust mask. When machining
concrete, man made fibre boards, especially MDF (medium Density Fibre Board)
the resin used in these materials can be hazardous to your health. Use an approved
face mask with replaceable filter.
Dust Extraction Equipment
If the machine is fitted with dust extraction and collection facilities ensure that
these are properly connected and used.
Do Not Abuse the Power Cord
Never yank or pull on the power cord to disconnect it from the mains supply socket.
Never carry your power tool by its power cord. Keep the power cord away from heat,
oil, solvents and sharp edges. If the power cord becomes damaged have it replaced
by an authorized service facility.
Secure the Work Piece
Wherever possible secure the work piece using clamps or a vice. It is safer than
using your hand and leaves both hands free to control the power tool.
Do Not Over-reach
Do not over-reach, keep proper footing and maintain your balance at all times.
Maintain Tools with Care
Keep cutting tools sharp and clean for better and safer performance.
Follow the instructions for lubricating and changing accessories.
Check the tool power cord periodically and if damaged have it replaced by an
authorized service facility.
Inspect extension cords periodically and if damaged replace it.
Keep handles dry, clean and free from oil and grease.
Ensure that ventilation slots are kept clean and free from dust at all times. Blocked
ventilation slots can cause overheating and damage to the motor.
Publicité
