Beurer BR 90 Mode D'emploi page 37

3. After the end of the application, an acoustic signal sounds, heating of the
heating plate
goes out. Remove the heating plate
4
the signal sounds.
4. If you want to switch on the light, slide the ON/OFF switch
towards the heating plate
The light is automatically switched off together with the device 2 min-
utes after use.
IMPORTANT
Depending on the sensitivity of the person using the device and of the area
of skin, the treatment temperature may feel unpleasant and cause slight
skin redness and, in rare cases, irritated skin. If the heat function feels too
hot, stop treatment immediately.
5. If required, you can use the heat function of the insect bite healer on
the sting/bite again after a break of 2 minutes or also use it immediately
on another sting/bite in a different area. The maximum number of 5 ap-
plications per hour on the same treatment area must not be exceeded.
6. If the device is no longer required, set it to "OFF" again using the ON/
OFF switch
status LED
7. Before storing, make sure that the device is switched off and the heat-
ing plate
3
is automatically stopped and the blue illuminated ring
3
. This is indicated by the "O" symbol. The blue device
2
turns off.
6
has cooled down.
3
with the
3
37
from the area of skin once
symbol; the light turns on.
further
2