Télécharger Imprimer la page

Mirolin Exploria HYT55P Guide D'installation page 10

Publicité

Step 1. Corner Shower Return Panel (T) Setup
NOTICE
If installing an Alcove Shower or Bathtub Door unit go to
Alcove Dam (M) Installation" on page 13
1 . Carefully, and with the assistance of another capable adult, lay the return panel
(T) down on a padded surface.
2 . Attach the bubble seal (U) to the inside edge of the return panel (T). Bubble seal
should be flush top and bottom, trim if required.
3 . Attach the two "L" shaped fixator assemblies (V) to the holes on the inside edge
of the return panel (T).
a . Place the "L" shaped fixator (V-1) and one of the gaskets (V-2) on the inside
of the return panel.
b . From the outside of the panel place fixator cover plate (V-3) and one of the
gaskets (V-2).
c . Secure the components together using the fixator screw (V-4) and a 3 mm
Hex wrench (T3).
d . Repeat steps "a-c" for the other "L" shaped fixator assembly (V).
DO NOT overtighten the fixator screw (V-4).
CAUTION
Étape 1. Préparation du panneau de retour de coin (T) de la
douche
AVIS
Si vous installez une porte de douche ou de baignoire d'alcôve, passez
à
"Étape 4. Installation de la bande de retenue d'eau (M) pour douche
d'alcôve" à la page 13
1 . Avec précaution, et avec l'aide d'un autre adulte compétent, posez le panneau
de retour (T) sur une surface rembourrée.
2 . Fixez le joint bulle (U) sur le bord intérieur du panneau de retour (T). Le joint
bulle doit être égal avec le haut et le bas du verre, ajustez si nécessaire.
3 . Fixez les deux ensembles de fixation en forme de « L » (V) aux trous situés sur le
bord intérieur du panneau de retour (T).
a . Placez la fixation en forme de « L » (V-1) et l'un des joints (V-2) sur l'intérieur
du panneau de retour.
b . À l'extérieur du panneau, placez la plaque/couvercle de la fixation (V-3) et
l'un des joints (V-2).
c . Fixez l'ensemble en utilisant la vis (V-4) et une clé hexagonale de 3 mm (T3).
d . Répétez les étapes « a » à « c » pour l'autre ensemble de fixation en forme
de « L » (V).
NE SERREZ PAS trop la vis de fixation (V-4).
ATTENTION
mirolin.com
INSTALLATION INSTRUCTIONS
INSTRUCTIONS D'INSTALLATION
"Step 4.
Page 10 / 27
216774, Rev. C
U
T
V-3
T
V-1
V-2
V-4
T3

Publicité

loading