Publicité
Les langues disponibles
Les langues disponibles
Factors affecting the sensor
The probe can operate in a pH range of between 6 and 8, an increase of
the pH value will affect the normal operation, since the signal / ppm ratio
is strongly reduced.
The presence of other oxidizing agents -such as ozone, carbon dioxide,
organic chlorine- will affect the reading, therefore these substances must
not be present in the water that must be analyzed. The water should not
contain surfactants and pH must be constant, with maximum variations
of ± 0.2 pH. The probe must work with a constant flow of water of at least
30 l / h, this is a necessary condition to obtain stable and precise
measurements. To ensure this flow rate you must use the appropriate
probe holder
S305.
Composition of supply
1
2
3
0000137887
Rev. 1.0
2
Publicité
