C-LITE C-WM-A-WDG Instructions D'utilisation page 2

INSTALLATION INSTRUCTIONS
C-WM-A-WDG
FIXTURE ADJUSTMENT
NOTE: Use the supplied hex key on the set screws on the mounting
canopy to level the fixture if necessary. Use the hex key on the set
screws on the fixture head to rotate the fixture head left or right as
necessary. The Phillips head screw on the fixture head knuckle can be
loosened to adjust the tilt angle of the fixture head as necessary.
1. Loosen set screw(s) or Phillips head screw See Figure 6.
2. Adjust fixture into desired position.
3. Re-tighten screw(s).
ELECTRICAL CONNECTIONS
Fixture is equipped with universal volt driver 120-277V
(ie. 120V, 208V, 240V or 277V)
PHASE TO NEUTRAL WIRING 120/277V
1. Connect supply ground to fixture ground (green) lead.
2. Connect supply common to fixture neutral (white) lead.
3. Connect supply Vin to fixture hot (black) lead.
Tuck all wires carefully into wiring chamber ensuring that no
wires are pinched.
PHASE TO PHASE WIRING 208/240V
1. Connect supply ground to fixture ground (green) lead.
2. Connect supply L1 (Hot) to fixture neutral (white) lead.
3. Connect supply L2 (Hot) to fixture hot (black) lead.
Tuck all wires carefully into wiring chamber ensuring that no
wires are pinched.
FCC NOTICE
CAUTION: Changes or modifications not expressly approved could void
your authority to use this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area
is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
CAN ICES-005 (A)/NMB-005 (A)
www.e-conolight.com |
Document:
Created By:
FIGURE 5
FIGURE 6
Set Screws
Mounting Canopy
888.243.9445 | FAX: 262.504.5409
Date
Mounting Canopy
Phillips Head
Screw
Fixture Head
Set Screws