BorMann BAT6120 Mode D'emploi page 3

• Use safety goggles and ear protection: Wear safety glasses with side shields when operating the tool and verify that others in the work area are also wearing
safety glasses. Always wear ear protection to help prevent hearing damage and loss.
DESCRIPTION OF MAIN PARTS (FIG. 1)
4
SPECIFICATIONS
Technical Data
Model
Maximum torque
Working torque
Square drive
No-load speed
Bolt size
Air inlet
Air hose (internal diameter)
Average air consumption
Working pressure
Net weight
AIR SYSTEM (FIG. 2)
• Always use clean, dry, regulated compressed air at 4 to 7 bar (60 to 100PSI).
• Do not exceed the maximum and minimum allowable pressure. Operating the tool at the wrong pressure (too low or too high) will cause excessive noise
and/or rapid wear.
• It is recommended that a filter-regulator-lubricator be used and be located as close to the tool as possible.
• If a filter-regulator-lubricator is not installed, place up to 6 drops of pneumatic tool oil into the air inlet plug before each use.
• If a filter-regulator-lubricator is installed, keep the air filter clean. A dirty filter will reduce the air pressure to the tool, which will cause a reduction in power,
efficiency, and general performance.
3
Fig. 1
BAT6120
1000 Nm
610 Nm
1/2''
8.500 rpm
16 mm
1/4''
3/8''
5 cfm
6.3 bar
1.45 kg
Quick connector
Air tool
Air hose
WWW.NIKOLAOUTOOLS.GR
2
1
* The manufacturer reserves the right to make minor changes to product design and technical specifications
without prior notice unless these changes significantly affect the performance and safety of the products. The
parts described / illustrated in the pages of the manual that you hold in your hands may also concern other models
of the manufacturer's product line with similar features and may not be included in the product you just acquired.
* To ensure the safety and reliability of the product and the warranty validity, all repair, inspection, repair or
replacement work, including maintenance and special adjustments, must only be carried out by technicians of the
authorized service department of the manufacturer.
* Always use the product with the supplied equipment. Operation of the product with non-provided equipment
may cause malfunctions or even serious injury or death. The manufacturer and the importer shall not be liable for
injuries and damages resulting from the use of non-conforming equipment.
Lubricator Filter
Quick coupler
Regulator
(0-8.5 bar)
Fig. 2
1. Air inlet
2. Direction of rotation knob
3. Trigger
4. Square drive head
Cut-off
valve
Air compressor
E N
3