Publicité
Les langues disponibles
Les langues disponibles
Light
Ambient light
Press the button once to turn on the ambient light, and press again up to 2 times to switch between brightness
levels.
SOS mode
Press and hold the button for 2 seconds to turn on SOS mode.
LCD Screen Guide
12
11
10
9
8
7
Current Output Power
Current Input Power
IoT
Press the IoT button once to turn on Bluetooth and Wi-Fi, and connect your devices through the app when this
icon appears on the screen.
Press the IoT button for 2 seconds to turn off Bluetooth and Wi-Fi.
Press the IoT button for 7 seconds to reset Bluetooth and Wi-Fi.
USB-A Output Port
USB-C Output Port
Car Charging
AC Charge and Voltage Frequency
05 EN
o
o
x1
x1
x2
x2
x3
x3
SOS
SOS
2S
2S
13
14
6
5
4
3
Low-Temperature Alert
When this icon shows, stop using the power station until the icon disappears.
High-Temperature Alert
When this icon shows, stop using the power station and let it cool down until the icon disappears.
Overload Warning
10
This icon appears when a port is overloaded. The port will be turned off to avoid any damage.
Please remove the device causing overload.
Estimated Time to Fully Recharge
11
Estimated Time for Battery to Deplete
12
Remaining Battery for Power Station
13
Power Saving Mode
14
Trouble Shooting
AC recharging failure
When AC recharging is unavailable, check to see if the overload protection switch is switched on. If so, press it
down to reset, and then recharging can resume.
AC charging failure
If AC charging is unavailable, it's possible that the connected devices exceed 1800W. Try unplugging one or more
1
of the connected devices to see if this resolves the issue.
Resetting your Power Station
If your Power Station isn't working correctly, press the reset button (located on the front of the product) for 1
2
second for a factory reset. If the Power Station still doesn't work, please visit support@anker.com
EN 06
Publicité
