Accessories; Before Use - Hilti TE 6-S Mode D'emploi

9. Insert tools and accessories
TE-C chuck
TE-C angular chuck
TE-AC 1 angular chuck
en
Hammer drill bits
Bit holder
Thin-barrel core bits
Keyless chuck (quick release)
Drill bits for wood
Drill bits for metal
Stepped (stop) drill bits
Hole saws
DRS dust removal module
9.1 DRS dust removal module
9.1.1 General information
Location of identification data on the tool
The type designation and serial number can be found on the type plate on the tool. Make a note of this data in your
operating instructions and always refer to it when making an enquiry to your Hilti representative or service depart-
ment.
Type:
9.1.2 Description
The DRS dust removal module is an accessory for the TE-6 rotary hammer drill. It can be attached to the rotary hammer
drill quickly and easily. The dust removal module is not suitable for chiselling work or for rotary drilling in metal.
9.1.3 Technical data
Power input
Suction performance
Weight
Maximum effective stroke
TE-C hammer drill bit diameter range (I
Drill bit working length
Contact pressure
Dust container capacity
") dia. / 28 mm (1.1") deep
6 mm ( 1 /
4
") dia. / 30 mm (1.2") deep
8 mm ( 5 /
16
") dia. / 50 mm (2") deep
12 mm ( 1 /
2
Dust container regeneration cycles
Extraction head
Extraction fan, dust container with folded filter, depth gauge, length stop, plug-type connection

9.1.4 Before use

Attaching the dust removal module
The extraction fan incorporated in the dust removal mod-
ule is driven by the motor of the rotary hammer drill by
way of a plug-type coupling. The teeth on the rotor shaft
(1) mesh with the teeth on the sleeve (2) of the dust
removal module drive shaft.
8
Printed: 07.07.2013 | Doc-Nr: PUB / 5071103 / 000 / 00
●
●
●
4–24 mm dia.
●
25–68 mm dia.
●
5–20 mm dia.
5–13 mm dia.
5–22 mm dia.
25–68 mm dia.
●
Serial no.:
Max. 60 W
500 l/min
0.9 kg
105 mm
/cm): 4–16 mm dia.
t
50–100 mm
15–25 N
130 holes
75 holes
20 holes
Up to 100 cycles
4–16 mm dia.
1. Unplug the supply cord.
2. Push the dust removal module along the guide (3) on
the rotary hammer drill until it engages securely in
place.
Removing the dust module
1. Unplug the supply cord.
2. Press the release latch (4) and hold it in this position.
"–1" dia.)
( 3 /
16
" dia.)
(1"–2 5 /
8
"– " dia.)
( 3 / 3 /
16 4
"– " dia.)
( 3 / 1 /
16 2
"– " dia.)
( 3 / 5 /
16 8
" dia.)
(1"–2 5 /
8
(2.03 lbs)
(4.1")
"– " dia.)
( 3 / 5 /
16 8
(2–4")
"– " dia.)
3 5
( / /
16 8