Manufacturer's Warranty - Tools - Hilti TE 6-S Mode D'emploi

Masquer les pouces Voir aussi pour TE 6-S:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3. Pull the dust module downwards away from the rotary
hammer drill.
9.1.5 Operation
Length adjustment (setting the stroke)
The stroke is normally set to TE-C drill bit I
(6"). This corresponds to an effective working length of
100 mm. The stroke must be adjusted if shorter drill bits
are used.
1. Open (A) the locking ring (5).
2. With the drill bit fitted in the chuck, press the tool
against the wall until the tip of the drill bit comes into
contact with the wall (C).
3. Close (B) the locking ring (5).
Setting the drilling depth (depth gauge)
1. Open (D) the end stop (6).
2. Slide the end stop to the desired drilling depth (F).
3. Close (E) the end stop (6).
When holes are to be drilled to a precise depth, e.g. for
setting anchors, the hole depth must be checked by drilling
test holes.
Changing the suction head
1. Pull back the rib (G) on the rear of the suction head
(7).
2. Pull the old suction head upwards out of the guide (H).
3. Press the new suction head into the guide until it
engages.
Emptying the dust container
1. Hold the tool horizontally and allow it to run for a short
time. This will cause any remaining dust particles in
the dust removal module to be sucked into the dust
container.
2. Press the button and hold it in this position (K).
3. Pull the dust container (8) downwards out of the dust
removal module (L).
4. Empty the dust container by tapping it lightly.
5. Slide the empty dust container into the dust module
from below until it engages in position. If you are insert-
ing a new dust container, remove the protective cov-
er before inserting it.
9.1.6 Care and maintenance
Use only compressed air and a cloth to clean the dust
removal module. Do not use water, oil, grease or clean-
ing agents.
Printed: 07.07.2013 | Doc-Nr: PUB / 5071103 / 000 / 00
10. Manufacturer's warranty – tools
Hilti warrants that the tool supplied is free of defects
in material and workmanship. This warranty is valid so
long as the tool is operated and handled correctly,
= 150 mm
t
cleaned and serviced properly and in accordance with
the Hilti Operating Instructions, and the technical sys-
tem is maintained. This means that only original Hilti
consumables, components and spare parts may be
used in the tool.
This warranty provides the free-of-charge repair or
replacement of defective parts only over the entire lifes-
pan of the tool. Parts requiring repair or replacement
as a result of normal wear and tear are not covered by
this warranty.
Additional claims are excluded, unless stringent
national rules prohibit such exclusion. In particular,
Hilti is not obligated for direct, indirect, incidental
or consequential damages, losses or expenses in
connection with, or by reason of, the use of, or inabil-
ity to use the tool for any purpose. Implied warranties
of merchantability or fitness for a particular purpose
are specifically excluded.
For repair or replacement, send tool or related parts
immediately upon discovery of the defect to the address
of the local Hilti marketing organization provided.
This constitutes Hilti's entire obligation with regard to
warranty and supersedes all prior or contemporane-
ous comments and oral or written agreements con-
cerning warranties.
en
9

Publicité

Table des Matières
loading

Table des Matières