SEVERIN KGK 8941 Mode D'emploi page 26

Change the Door Stop
• If necessary, the door can be changed from right-
to left-hinged.
• Warning! Before you work on the appliance,
always pull the mains plug out of the point.
• In order to avoid damages to persons and prop-
erty, execute the change of the door stop with
two persons.
• We recommend leaving the change of the door
stop to experts.
• Before you start with the modifications, here is
some general info:
ū Always pay attention to the number of shims
on the bearing pins and screws.
ū Position the doors always so that they close
tightly.
a) Unscrew the cover of the door hinges and
remove it. .
b) Unplug the cable. Unscrew the 4 screws that
hold the upper hinge and remove it. Take off the
loop on the ground cable of the hinge. Insert the
cable connection in the opening on the top of the
appliance. Take off the door jack and the cover
of the small end caps.
8941_42_45_46_multi_(originates_from_8955_56).indd 26
c) Put the door jack and the cable connection in
the opening on the door and then attach the
small end cap.
Step 1
d) Loosen 2 screws as shown in the figure below, in
order to remove the gap caver on the top side of
the appliance. Remove the small end cap cover
on the door and take out the door socket and the
cable connection.
e) Put the door socket in the round opening on the
door and attach the small end cap cover.
- 26 -
18.09.2018 15:14:23