Philips AVENT SCF330 Mode D'emploi page 7

Caution
- The breast pump is only intended for repeated use by a single user.
- Never drop or insert any foreign object into any opening.
- Never use any accessories or parts from other manufacturers or that Philips AVENT does
not specifically recommend.
- Do not use antibacterial or abrasive cleaning agents when you clean breast pump parts.
- Do not continue pumping for more than five minutes at a time if you do not succeed in
expressing any milk.
- If the pressure generated is uncomfortable or causes pain, break the seal between the breast
and the pump body with your finger and remove the pump from your breast.
Philips AVENT storage cups (SCF330/13 only), Natural bottle (all types except
SCF330/13), cap, screw ring and teat
For your child's safety and health:
WARNING!
- Continuous and prolonged sipping of fluids will cause tooth decay.
- Always check the food temperature before feeding.
- Do not allow your child to play with small parts or to walk/run while it is using bottles or cups.
- This product may break if dropped.
- Do not place the bottle or storage cups in a hot oven or on any other hot surface.
- Never use feeding teats as a soother.
- Inspect before each use and pull the feeding teat in all directions. Throw away at the first signs
of damage or weakness.
- Do not leave a feeding teat in direct sunlight or heat, or leave in disinfectant ('sterilising solution')
for longer than recommended, as this may weaken the teat.
- Clean before each use.
Preparing for use
Clean and sterilise all parts of the breast pump before first use as described in chapter 'Cleaning and
sterilising'. Clean all parts after each subsequent use and sterilise all parts before each subsequent use.
Assembling the breast pump
Note: Make sure you have cleaned and sterilised all parts of the breast pump. Wash your hands
thoroughly before you handle the cleaned parts.
Be careful, the cleaned parts may still be hot.
Tip: You may find it easier to assemble the breast pump while it is wet.
1 Insert the white valve into the pump body from underneath. Push in the valve as far as
possible (Fig. 2).
2 Screw the pump body clockwise onto the bottle or storage cup until it is securely
fixed (Fig. 3).
Note: If you use a storage cup, you have to screw the adapter onto the storage cup first.
3 Place the silicone diaphragm with stem into the pump body from above. Make sure it fits
securely around the rim by pressing down with your fingers to ensure a perfect seal (Fig. 4).
4 Attach the handle onto the diaphragm with stem by hooking the hole in the handle over the
end of the stem. Push down the handle onto the pump body until it clicks into place (Fig. 5).
5 Place the massage cushion into the funnel-shaped section of the pump body. Push in the inner
part of the massage cushion as far as possible and make sure that it is perfectly sealed all
around the rim of the funnel. Press in between the petals to remove any trapped air (Fig. 6).
All manuals and user guides at all-guides.com
ENGLISH
7