Publicité
Les langues disponibles
Les langues disponibles
b) When you long press 2 seconds, it shows the time then it is activated as cyclical mode of following
functions for user's selection.
-> INVOL
-> DSP (Rotate the VOL knob to adjust
the HOUR or MINUTE)
-> BEEP (ALL/OFF/2ND)
-> TAVOL->EON ON/OFF
-> REG ON/OFF
-> AF (ON/OFF)
After selecting the desired mode, rotate the VOL knob to select one setup item of the desired mode.
1) TA [TRAFFIC ANNOUNCEMENT]
When TA mode is on (TA is displayed on LCD), it will begin to seek TA station and TA SEEK will be displayed
on LCD for a while.
When traffic announcement is transmitted:
(1) If the unit is in USB or disc mode, it will switch to radio mode temporarily. Temporarily switch over to an
EON linked station when EON detects traffic announcement on that other program, and TP will be displayed
on LCD.
(2) If volume level is below 20, volume level is raised to 20, and returns to its previous mode and volume
level when the traffic announcement is over.
(3) If volume is adjusted during traffic announcement, only the traffic announcement volume is valid.
*
TA interruption function:
The current traffic announcement is cancelled by pressing this key. But the TA mode will not be off.
*
When TA is on, SEEK, (SCAN), AUTO MEMORY function can be received or saved only when traffic
program identification code has been received.
2) AF [ALTERNATIVE FREQUENCIES]
When AF switching mode is selected; AF indicator is displayed on LCD display.
AF indicator is off: AF switching mode off.
AF indicator is on: AF switching mode on, and has RDS information.
AF indicator is flashing: AF switching mode on, but RDS information is not received yet.
When AF switching mode is selected, the radio checks the signal strength of ALTERNATIVE
FREQUENCIES all the time. The interval of checking time of each ALTERNATIVE FREQUENCY depends
on the signal strength of current station, from a few minute for strong station to a few seconds for weak
station. Every time that new AF is stronger than current station, it switches over to that frequency for very
short time, and NEW FREQUENCY is displayed for 1-2 seconds. Because the mute time of AF switching or
checking time is very short, it is almost inaudible in case of normal program.
In FM mode, when AF is on, SEEK, (SCAN), AUTO-MEMORY function can only receive and save RDS
program.
PDF created with FinePrint pdfFactory Pro trial version
All manuals and user guides at all-guides.com
5. OPERATION OF THE CONTROLS
-> EON (ON/OFF)
-> TA (ON/OFF)
-> EQ ON/OFF
-> LOUD (ON/OFF)
-> LOC ON/OFF (only for FM mode)
-> MONO/STEREO (only for FM mode)
-> AREA (EUR/USA)
25
http://www.pdffactory.com
Publicité
